Home Improvement, Remodeling and Repair @ Builders Websource. Home design software, advice, tools, videos, tech notes, links and more!

Search: 

Home Page | Books | BuildersTALK | Building a Dream | Green Building | Links | Software | Tech Notes | Tools | Contact

Messages and Online Forum Q&A

If you find the answer to this question useful, kindly CLICK TO PAY here.



Knowledge


BuildersTALK
Building|Dream
Green Building
How-To Books
Links (Web)
Newsletter
Tech Notes
Videos

Software


BeamChek
Bidding
CAD | AutoCAD
Estimating
EZHomeBuild
Home Design
Landscaping
Lighting Design
PrioSoft
Resi-Cost
Structural

Specialty Tools


CrackMON
Tools
WatrLevel

Support & Info


About Us
Advertise
Contact Us
FAQ
Publish
Services
Support

 

Floor Reinforcement

From: tack@yahoo.com
Category: Structural
Remote Name: 4.11.126.18
Date: 22 Feb 2004
Time: 11:13 AM

Comments

I have a question about reinforcing an existing kitchen floor that spans our garage, directly below. Our two-story masonry home is built over a walk-out basement/garage. The kitchen is directly over the garage portion of the basement and, of course, has a garage door that opens only a couple inches from the ceiling. The kitchen floor is covered with heavy mud-set Satillo tile and is subject to springiness and vibration. Our contractor has indicated that the joists are causing the problem. I concur from what we have observed when opening the downstairs ceiling. The potential solution is complex because of two issues: 1) floor spans garage, so center posts are impractical and 2)garage-door clearance at ceiling restricts depth of any spanning beam. The floor in question, spanning the garage, is 18.5' x 13.5', the joists (T-lams) running in the 13.5' direction and on 16" centers. The joist ends are supported on each end by the masonry wall on one side and 4 bolted and laminated 16" microlams on the other. There seem to be only two possibilities for adding strength and rigidity to the floor support system: 1) sistering the joists or 2) bisecting the joists with a new beam, effectively halving their spanning distances. The questions with these two approaches are: 1) will sistering the joists in fact add enough strength and rigidity to elimiante deflection and vibration? 2) if a new beam is employed, because of the garage-door clearance, would need to be no more than 12" (maybe, 14", but doubtful) in depth. Further complicating use of a beam is that where it would need to be supported on its ends requires spanning 25', rather than 18.5'. So, the questions are: 1) Is sistering effective in this case? 2) Can a beam be employed (25' x 12" depth) that will effectively span this distance with correct load and rigidity characteristics? A steel I-beam? Other? Any assistance and insights appreciated. If possible, please reply to tack@yahoo.com, as well as any reply posting to web site. Thanks.

 

Article Tools

BuildersTALK


Ask an Expert
Recent Questions
Click to Pay

Archives


2006-2007
Oct-Dec 2002
Jul-Sep 2002
Jan-Jun 2002
Jul-Dec 2001
Jan-Jun 2001
1999-2000

 

 


ASTM International